5. Unpacking and Initial Setup
5.3. Assembling (4/4)
Assembling
Attaching Waste Ink Tank
Attach the waste ink tank to the printer.
[1] Place the waste ink tank on the waste ink tank holder.
[2] Use the waste ink tank tube to connect the waste ink tank to the printer.
・ Cover up the connector of the tank with the tube.
Connect the waste ink sensor cable to the waste ink sensor connector.
Check that the connector of the tank is fully covered with the tube.
Failure to do so may cause ink spillage.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.12)
Page.
5.4. Connecting Power and Network (1/2)
Connecting Power and Network
Connect Power Cords and Ethernet Cable
Follow the steps below to connect the power cords and Ethernet cable.
[1] Check that the front cover is closed.
[2] Connect two power cords and a Ethernet cable to the printer.
Make sure to plug two power cords into the wall outlets with the same voltage.
Failure to do so may cause damage to the electrical circuit.
26
To Table of Contents
cf. Startup Guide(Rev.01-p.13)
CONFIDENTIAL