Assembling; Assembling Stand; Attach The Left Leg And Right Leg To The Brace; Attach The Foot To The Leg - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.2. Unpacking (4/4)
Unpacking
Unpacking Stand
[2] Check that the following items are included.
Items marked with an asterisk (*) above are in the accessory box.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.7)
Page.

5.3. Assembling (1/4)

Assembling

Assembling Stand

Follow the steps below to assemble the stand.
・ Minimum two people are required for assembling the stand.

[1] Attach the left leg and right leg to the brace.

・ Face the groove on the brace toward the rear side of the printer and attach it to
both legs.
・ The leg with two warning labels attached is the right leg.
・ Put the spring washers on the hex head screws (4 each), then tighten the screws.

[2] Attach the foot to the leg.

・ Face the screw holes on the foot toward the front side of the printer and attach it
to the leg.
・ Put the spring washers on the hex head screws (4 each), then tighten the screws.
・ Use the round head screws (×8) to fix the fixing brackets (×2) on the brace and
both legs.
23
To Table of Contents
cf. Startup Guide(Rev.01-p.8)
CONFIDENTIAL