MUTOH XpertJet XPJ-1641SR Training Manual page 35

5. Unpacking and Initial Setup
5.6. Test Printing (2/5)
Test printing
Load a roll media into the printer
2. Enable torque on media holders (1/2)
If you want to apply torque to the media holders, follow the steps below.
[1] Twist the knob bolt on the right side of the media
holder
anticlockwise to loosen.
[2] Twist the knob bolt on the left side of the media
holder anticlockwise to loosen.
[3] Slide both left and right media holders about 30
cm towards the center of the slider for easy
access.
[4] Tighten the knob bolts on both media holders.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.29)
Page.
Load a roll media into the printer
2. Enable torque on media holders (2/2)
[5] (When looking from the rear side of the printer)
Use the screwdriver to loosen two screws securing
the roller shaft guide plate to the right media
holder.
[6] Slide up the roller shaft guide plate as far as it will
go and tighten the screws.
[7] Do the same for the left media holder to slide up
the roller shaft guide plate as far as it will go and
tighten the screws.
The shape, number of screws, and mounting
location differ between left and right guide plates.
[8] Loosen the knob bolts and slide back both media holders to the original position.
[9] Tighten the knob bolts.
3. Place the media onto the media holder (1/3)
[1] Twist the knob bolt on the right side of the media
holder anticlockwise to loosen.
35
To Table of Contents
cf. Startup Guide(Rev.01-p.30)
CONFIDENTIAL