MUTOH XpertJet XPJ-1641SR Training Manual page 42

5. Unpacking and Initial Setup
5.8. Setting the Printing Precision (3/13)
Calibrating your printer
Head alignment (XPJ-1682SR Only)
Head adjustment pattern
・ Press the [Enter] key to carry out printing.
For the Head adjustment pattern, the same patterns will be printed on both sides
and center of the media.
・ Check the print results and select the number that looks most aligned between 1 and
7.
・ Pattern names such as "Pattern B: 4" are shown on the display.
・ Use the / key to enter the number of the bestadjusted pattern, and press the
[Enter] key.
・ In the case of the picture below, enter "5", so that the display reads "Pattern B: 5".
・ If you selected "Head Adj. 2: Custom" and "Fine Pattern ALL", enter the adjustment
value for A to F.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.97)
Page.
Head alignment (XPJ-1682SR Only)
When "Adjust Head 3 Auto" is selected
You can select the adjustment method.
Tap
Perform the automatic adjustment using the embedded color sensor.
If the resolution, pass and the printing direction of the RIP print mode differ from the
print mode for the User Type, select the fine pattern that is suitable for the RIP.
Submenus
42
To Table of Contents
cf. Operation Manual(Rev.01-p.97)
to open the submenu.
Perform automatic adjustment for all patterns
(A to F) using the color sensor.
Perform automatic adjustment for the currently
selected print mode using the color sensor
(calibrate the same print mode as "Adjust
Head1 Standard").
Choose the adjustment pattern between A and
F for automatic adjustment.
CONFIDENTIAL