Attaching Printer - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.3. Assembling (2/4)
Assembling
Assembling Stand
[3] Use the round head screws (×4) to attach the waste ink tank holder to the right leg.
[4] Shake the stand to make sure that each part is firmly attached.
[5] Turn the leveling adjusters (×4) as shown on the left until the stand does not move.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.9)
Page.

Attaching Printer

Follow the steps below to attach the printer to the stand.
・ Minimum four people are required for this process.
・ When taking out the product from the packing box, remove the plastic sheet
wrapped around the product, then take out the product.
Failure to do so may cause slip and damage to the product.
・ Keep the product level while attaching.
[1] Lift the printer with at least four people and mount it on the stand.
・ Use two lifting bars to insert into the guide holes at the bottom left and right of
the printer, and lift up on the stand.
(If you do not have lifting bars) Lift the printer with at least four people and mount
it on the stand.
・ Use the handholds at the front bottom of the printer.
[2] Use the wing bolts (×8) and attach the printer to the stand.
24
To Table of Contents
cf. Startup Guide(Rev.01-p.9)
CONFIDENTIAL