MUTOH XpertJet XPJ-1641SR Training Manual page 65

7. Carriage
7.4. Color Sensor (3/3)
Print quality calibration
Sets up when adjusting the printer for the optimum
quality of image print.
Before adjusting this setting, enter the thickness of
the media.
Submenus
Print quality calibration
Adjust Print 3: Auto
Perform the automatic adjustment using the
embedded color sensor.
Submenus
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.63)
Adjusts only the print mode in the user type
setting which is currently set.
Adjusts the print modes other than the mode
in the user type setting which is currently set.
Perform an automatic calibration that the
printer automatically prints and scans a pattern
with the embedded color sensor to correct dot
placement.
cf. Operation Manual(Rev.01-p.64)
Perform automatic adjustment for all patterns
(A to F) using the color sensor.
Perform automatic adjustment for the currently
selected print mode using the color sensor
(calibrate the same print mode as "Adjust Print
1 Standard").
Choose the adjustment pattern between A and
F for automatic adjustment.
Print quality calibration
Auto Adjustment Method
1. Select the adjustment pattern from "ALL", "Standard", or any specific pattern
between "Adjust Pattern A" and "Adjust Pattern F".
・ The selected adjustment pattern is printed.
・ The printer scans the print using the embedded color sensor, then automatically
corrects the dot placement.
2. Once successfully completed, the message "Auto Adjust Succeeded End->Enter" will
appear on the panel.
・ If failed, the message "Auto Adjust Failed End -> Enter" will appear on the panel.
Tap [Enter] to end the adjustment.
・ Try Auto Adjust again or perform Standard or Custom adjustment.
3. Tap [Enter] to exit the menu.
・ If failed in the middle of the calibration, the adjustment value for the pattern which
has been successfully calibrated will be saved in the printer, but the adjustment
value for the pattern which has been failed to calibrate or has not been calibrated yet
will not be saved in the printer.
・ Warm up the heater before printing the Confirm and Adjustment patterns.
"Skip Heater Warm Up? No" is displayed on the front panel.
・ You can start printing while the printer is warming up.
・ If print defects (like banding or grainy look) still appear on the print, try an auto
calibration again, or go to "Adjust Print1/ Standard" or "Adjust Print2/ Custom" to
perform calibration.
・ If a roll media starts to cockle during calibration, load the media again.
While "Warming Up" is displayed, do not touch Media guide.
You could burn yourself.
Page. 65
To Table of Contents
cf. Operation Manual(Rev.01-p.68)
CONFIDENTIAL