MUTOH XpertJet XPJ-1641SR Training Manual page 36

5. Unpacking and Initial Setup
5.6. Test Printing (3/5)
Test printing
Load a roll media into the printer
3. Place the media onto the media holder (2/3)
[2] Place the roll media onto the left media holder.
Carefully and gently place it on the holder.
(If torque is enabled)
①: When looking from the left side, check that the protrusion on the roller shaft
guide plate is fitted into between two protrusions on the flange end cap.
②: When looking from the rear side of the printer, check that the flange end cap is
properly placed on the protrusion on the roller shaft guide plate.
Do not drop or apply excessive impact while placing the media.
This will cause damage to the part.
(If torque is disabled)
・ Check that the stopper on the shaft is fitted into the slit as shown in the
illustration (not on the media holder).
When you adjust the position of the media holder (left), do not move it more
than 450 mm away from the left-hand end.
The printer will not be able to detect media.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.30)
Page.
Load a roll media into the printer
3. Place the media onto the media holder (3/3)
[3] Slide the right side of the media holder to place the right side of the flange onto the
holder.
Place the roll media onto the right media holder.
Carefully and gently place it on the holder.
(If torque is enabled)
①: When looking from the right side, check that the protrusion on the roller shaft
guide plate is fitted into between two protrusions on the flange end cap.
②: When looking from the rear side of the printer, check that there is a gap
between the protrusion on the roller shaft guide plate and stopper on the shaft.
・ Do not drop or apply excessive impact while placing the media.
This will cause damage to the part.
・ If the stopper gets contact with the guide plate as "No Good" example
below, it may cause damage to the part.
(If torque is disabled)
・ Check that the stopper on the shaft is fitted into the slit as shown in the
illustration (not on the media holder).
[4] Twist the knob bolt on the right side of the media
holder clockwise to tighten.
36
To Table of Contents
cf. Startup Guide(Rev.01-p.31)
CONFIDENTIAL