Cleaning The Color Sensor - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance
11.8. Cleaning around the print head (2/2)
Cleaning
Cleaning around the print head
Step (3/3)
[5]
[6] Close the front cover.
[7]
[8]
cleaning stick should be put in a plastic bag, etc, and dispose of it in compliance with
local ordinance and instructions of local authorities
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.126)
Close the maintenance cover.
Tap [Enter].
Tap [Home] to end the cleaning process.
11.9. Cleaning around the color sensor (1/2)
Cleaning

Cleaning the color sensor

Cleaning period:
・ If you repeatedly failed to perform an auto head alignment or auto print quality
calibration .
Preparation:
・ Cleaning stick
・ Ethanol (commercially available item: Use one with a concentration of 50% or higher.)
During cleaning, please note the followings.
・ Do not push the glass on the color sensor too hard with a cleaning stick.
This will damage the glass.
・ Do not reuse a cleaning stick.
Dust may adhere to the color sensor causing malfunction.
・ This cleaning takes about 5 minutes.
If it takes longer, the stick will get dry causing damage to the print head.
Step (1/3)
[1] Put the printer into the CR maintenance mode.
[2] Open the front cover.
[3]
Page. 112
To Table of Contents
cf. Operation Manual(Rev.01-p.127)
Open the maintenance cover on the left side.
CONFIDENTIAL