MUTOH XpertJet XPJ-1641SR Training Manual page 38

5. Unpacking and Initial Setup
5.6. Test Printing (5/5)
Test printing
Load a roll media into the printer
5. After loading the media... (1/2)
[1] From the front side of the printer, push the media
feed lever to hold the media flat with pressure
rollers.
Using this lever, the pressure applied to the rollers
can be changed between High and Normal.
Normally push the lever until it clicks to apply
normal pressure.
[2] Check that the pressure rollers hold down the both edges of the media properly.
・ If it holds as a "No Good" example, pull the media feed lever towards you as
much as possible, then adjust the position of the left or right side of the media
holder until the both edges of the media are held down properly
(see "Place the media onto the media holder" for more details).
[3] Place the edge holders on both edges of the media.
In the default setting, the printer starts printing with 5 mm margin on the
sides.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.34)
Page.
Load a roll media into the printer
5. After loading the media... (2/2)
[4]
[5]
[6]
[7]
The side margin can be set between 5mm and 25mm.
・
[8]
[9]
38
To Table of Contents
cf. Startup Guide(Rev.01-p.34)
Tap [Home].
Tap .
Tap until the menu on the left appears.
・ Tap .
Set the side margin to 10 mm minimum.
・ Use or to choose the alignment method.
・ Tap [Enter].
Close the front cover.
"User: Type** OK?" appears on the front panel.
・ Use or to choose the correct user type
and tap [Enter] to start media initialization.
End the media loading.
CONFIDENTIAL