MUTOH XpertJet XPJ-1641SR Training Manual page 37

5. Unpacking and Initial Setup
5.6. Test Printing (4/5)
Test printing
Load a roll media into the printer
4. Load the media into the printer (1/2)
[1] Check that the printer is powered on.
[2] From the front side of the printer, fully pull the
media feed lever towards you to release the
pressure rollers.
You can access to the media feed lever from the
rear side of the printer.
・ To release the pressure rollers, push the lever as
far as it goes.
[3] Open the front cover.
[4] From the rear side of the printer, insert the front
edge of the media into the media slot.
Before inserting, rewind the media properly.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.32)
Page.
Load a roll media into the printer
4. Load the media into the printer (2/2)
[5] From the front side of the printer, pull the media
for approximately 1m.
[6] While one person holds the front edge of the media, the other person turns the
flange to slightly rewind the media onto the roll to remove warp or skew.
If you remove your hands from the front edge of the media while rewinding, the
media can be removed from the media slot.
[7] Check that the right-hand edge of the media is located at the left side of the media
guide line.
If not, print quality can be affected.
[8] If needed, use a slide lock lever on the pressure rollers to individually cancel or
reduce the pressure.
37
To Table of Contents
cf. Startup Guide(Rev.01-p.33)
CONFIDENTIAL