Set 23: Header Dump; Set 24: Single Head - MUTOH VJ-1938TX Operation Manual

Set 23: Header Dump

Set 23: Header Dump
Note
• The data will be useful when contacting technical support.
• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are printed on data header.

Set 24: Single Head

Set 24: Single Head
Note
• This printer has 2 Print heads inside Print head unit.
• Even if "Head 1" or "Head 2" is set, when performing the Test print menu, the both Print heads are used for printing.
• When "Head 1" or "Head 2" is set, if "A-S. Fine&Wave" or "B-S.Fine&Wave" is selected, the selected Print head is further divided for printing.
88

Set 23: Header Dump

Sets whether to print the following information when printing.
• Data header
• Data dot number (printed only when Header damp setting is ON)
• Printer serial number
• Firmware version
Setting values
Header Dump : OFF
Header Dump : ON
Header Dump : DUMP
You can set whether or not to perform printing using only one Print head.
Setting values
Single Head : OFF
Single Head : Head 1
Single Head : Head 2
Dump data is not printed.
This is the initially set value.
Dump data is printed after the original image is
printed.
Prints only damp data.
"Data dot number" is not printed.
Both Print heads are used for printing.
This is the initially set value.
Only left Print head is used for printing.
Only right Print head is used for printing.