Removing Packing Materials - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.3. Assembling (3/4)
Assembling

Removing Packing Materials

Remove packing materials from the product.
[1] Remove the packing tapes from all the covers.
[2] (XPJ-1682SR only) Remove two screws each (M3 x 45) to remove two front cover
locks.
Make sure to remove two front cover locks before opening the front cover.
Otherwise it will cause damage to the cover.
[3] (XPJ-1682SR only)
①: Open the front cover and remove two screws each (M4x8) to remove two front
cover lock plates.
②: Use the screws just removed to fasten to the mounting holes on the printer.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.10)
Page.
Removing Packing Materials
[4] Open the front cover. Remove the wing bolt to remove the shipping bracket from
the carriage.
[5] （XPJ1682SR only）Remove the tape, then remove the packing material from the
bottom of the carriage.
[6] Remove the tape, and move the edge holders to the left and the right edge.
25
To Table of Contents
cf. Startup Guide(Rev.01-p.11)
CONFIDENTIAL