Installing The Ink Bag - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance
11.3. Checking ink and replacing ink bag (3/3)
Checking ink and replacing ink bag
Replacing ink bag
2.

Installing the ink bag (1/2)

[1]
[2]
[3]
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.113)
Prepare the new ink bag, and follow the
instructions below to invert it to mix the ink.
・ Face the ink spout side upwards for 3 seconds.
・ Invert it and count for 3 seconds.
・ Repeat that 3 times.
Put the ink bag into the case.
Close the ink bag case.
Make sure the spout of ink bag is properly
fitted into the groove in the case.
If not fitted, the printer cannot correctly
detect ink bag.
Close all the latches (×4) of the case properly.
Check that all the latches (×4) are closed.
If not, it may cause ink spillage.
Replacing ink bag
2. Installing the ink bag (2/2)
[4] Insert the ink bag case with the new ink bag installed and new S/C card into each
slot.
・ Match the colors of the ink color indicating label on the printer and the label on
the ink bag.
・ Face the latch side toward you and insert the case into each slot.
・ Make sure that they are fully inserted.
Page. 105
To Table of Contents
cf. Operation Manual(Rev.01-p.114)
CONFIDENTIAL