11. User Maintenance
11.11. Replacing absorption material for the flushing box (1/2)
Replacing consumable parts
Replacing absorption material for the flushing box
The flushing box is a part that keeps receiving ink discharged from the print head.
Please replace the absorption material for the flushing box periodically.
If used without replacing, it can cause damage to the print head.
Replacing period:
・
Approx. every two months
(since it differs depending on usage frequency, please check periodically)
Preparation:
・
Absorption material for the flushing box
・
Paper you can get dirty (paper which ink will not bleed through)
1.
Checking steps (1/2)
[1] Open the front cover.
[2]
[3]
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.130)
Open the maintenance cover on the right side.
Check the absorption material for the flushing box.
・ When there are lumps of ink rise from the frame
of the flushing box, it is time to replace.
Replacing absorption material for the flushing box
1.
Checking steps (2/2)
[5]
[6] Close the front cover.
2.
Replacing steps (1/3)
[1] Put the printer into the CR maintenance mode.
[2] Open the front cover.
[3]
[4] Cover the platen with the paper you can get dirty.
Ink may drip from the absorption material for the flushing box.
We recommend covering the floor with paper as well.
Page.
115
To Table of Contents
cf. Operation Manual(Rev.01-p.130)
Close the maintenance cover.
Open the maintenance cover on the right side.
CONFIDENTIAL