Pf Adjust; Platen Heater; Dryer; Vacuum Fan - MUTOH XpertJet XPJ-1641SR Training Manual

9. Printing
9.1. User Type (4/5)
Menu 1: Setup
**>3: PF Adjust
Sets up various settings on the Media feed correction.
When the following defects are found in printing
results, they may improve by conducting a media feed
correction.
・ Images are overlapping.
・ There are white lines in images.
Submenus
**>4: Pre Heater
Sets up Pre Heater.
Use
Setting values
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.69)
Performs Initial Print. Enter the "Feed Length"
and tap [Enter].
Use or to enter the adjustment value,
and tap [Enter].
Performs Confirm Print.
Enter the "Feed Length" and tap [Enter].
Performs Micro adjustment Print.
Enter the appropriate micro adjustment value
according to the print result.
Use or to enter the adjustment value,
and tap [Enter].
Select whether you wish to perform
confirmation print and complete the setup.
or to select the value, and tap [Enter].
Off / <30℃> to 50℃
<> indicates the initial value.
Menu 1: Setup
**>5: Platen Heater
Setting values
**>6: Dryer
Setting values
**>7: Vacuum Fan
Setting values
Page. 75
To Table of Contents
cf. Operation Manual(Rev.01-p.74)
Sets up Platen Heater.
Use or to select the value, and tap [Enter].
Off / <30℃> to 50℃
<> indicates the initial value.
Sets up Dryer.
Use or to select the value, and tap [Enter].
Off / <30℃> to 50℃
<> indicates the initial value.
Selects the vacuum level.
Use or to select the value, and tap [Enter].
・ If you are using a thin or delicate media and there is
risk of it wrinkling due to the fan, set a lower value
for the fan.
Low / Medium / <High>
<> indicates the initial value.
CONFIDENTIAL