Cleaning Around The Print Head - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance

11.8. Cleaning around the print head (1/2)

Cleaning
Cleaning around the print head
Cleaning period:
・ When print blurring and dot missing remain after head cleaning is done.
Preparation:
・ Cleaning stick
During cleaning, please note the followings.
・ Use a dry cleaning stick
A damp stick can cause damage to the print head.
・ Do not touch the tip of a cleaning stick with fingers.
Skin oil will damage the print head.
・ Do not reuse a cleaning stick.
Dust on the stick will damage the print head.
・ This cleaning takes about 5 minutes.
If it takes longer, the stick will get dry causing damage to the print head.
Step (1/3)
[1] Put the printer into the CR maintenance mode.
[2] Open the front cover.
[3]
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.125)
Open the maintenance cover on the left side.
Cleaning around the print head
Step (2/3)
[4] Use the cleaning stick to remove the ink deposits or dust on the bottom of the
carriage.
Page. 111
To Table of Contents
cf. Operation Manual(Rev.01-p.125)
CONFIDENTIAL