When It Becomes Time To Replace Ink Bag; Replacing Ink Bag; Removing The Ink Bag Case - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance
11.3. Checking ink and replacing ink bag (2/3)
Checking ink and replacing ink bag

When it becomes time to replace ink bag

When the ink level becomes low, the error LED of the front panel flashes and a buzzer
sounds.
[1]
[2] Prepare the replacement ink bag.

Replacing ink bag

When an ink bag runs out of ink, the error message [Ink End] or [S/C Ink End] appears
on the panel with blinking error LED and beep sound.
Replace an ink bag immediately.
The printer will not resume printing until the ink bag is replaced.
・ Do not replace ink bag when the printer is powered off.
Ink level cannot be detected correctly.
・ If ink bag is moved from cold to warm place, leave it in the room temperature
at least three hours.
・ If you do not have any replacement ink bag, do not remove the empty ink bag
from the printer.
This may cause the nozzle clogs.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.112)
Tap [Enter].
・ The buzzer stops
・ In the figure to the left, the slot 4 ink bag is
nearing replacement.
Replacing ink bag
1.

Removing the ink bag case

[1]
[2] Remove the ink bag case and S/C card that you need to replace from each slot.
[3]
[4]
Page. 104
To Table of Contents
cf. Operation Manual(Rev.01-p.112)
Tap [Enter].
・ The buzzer stops.
・ In the figure to the left, the slot 4 ink bag must
be replaced
Open the ink bag case.
Remove the empty ink bag
Place the used ink bag in a plastic bag or the like
and dispose of the ink bag according to the local
regulations.
CONFIDENTIAL