Confirm Pattern; Rough Adjustment Pattern - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.8. Setting the Printing Precision (8/13)
Calibrating your printer
Print quality calibration
Standard or Custom Adjustment Methods
1. Print a confirm pattern and check it for printing errors.
2. Print "Rough pattern" and look for a place that is properly adjusted in the printing
results of print head 1.
・ If you selected "Adjust Print 2: Custom", select "ALL" or "A" to "F".
・ The number printed under the pattern without alignment errors is the adjustment
value.
3. Enter the adjustment values.
4. Follow the same procedure to adjust print head 2 (XPJ-1682SR Only).
5. Print "Fine pattern" and look for a place that is properly adjusted in the printing
results of print head 1.
・ If you selected "Adjust Print 2: Custom", select "ALL" or "A" to "F".
・ The number printed under the pattern without alignment errors is the adjustment
value.
6. Enter the adjustment values.
7. Follow the same procedure to adjust print head 2 (XPJ-1682SR Only).
・ Warm up the heater before printing the Confirm and Adjustment patterns.
"Skip Heater Warm Up? No" is displayed on the front panel.
・ You can start printing while the printer is warming up.
While "Warming Up" is displayed, do not touch Media guide.
You could burn yourself.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.66)
Page.
Print quality calibration

Confirm pattern

・ Press the [Enter] key to carry out printing.
・ Check the printing results. If there are shifting problems, proceed to rough
adjustment pattern printing.
・ In the picture below, there are misalignments.
Because XPJ-1682SR has 2 Print heads, 2 rows of confirmation pattern will be printed.

Rough adjustment pattern

・ Tap [Enter] to carry out printing.
・ For Head 1, check the print results and select the number that looks most aligned between 1 and 21.
・ Pattern names such as "Pattern B1: 11" are shown on the display.
Use or to enter the number of the best-adjusted pattern, and tap [Enter].
・ In the case of the picture below, enter "12", so that the display reads "Pattern B1: 12".
Follow the same procedure to adjust print head 2 (XPJ-1682SR Only).
47
To Table of Contents
cf. Operation Manual(Rev.01-p.67)
CONFIDENTIAL