MUTOH XpertJet XPJ-1641SR Training Manual page 50

5. Unpacking and Initial Setup
5.8. Setting the Printing Precision (11/13)
Calibrating your printer
Media feed adjustment
Sets up various settings on the Media feed correction.
When the following defects are found in printing
results, they may improve by conducting a media feed
correction.
・ Images are overlapping.
・ There are white lines in images.
Submenus
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.69)
Performs Initial Print. Enter the "Feed Length"
and tap [Enter].
Use or to enter the adjustment value,
and tap [Enter].
Performs Confirm Print.
Enter the "Feed Length" and tap [Enter].
Performs Micro adjustment Print.
Enter the appropriate micro adjustment value
according to the print result.
Use or to enter the adjustment value,
and tap [Enter].
Select whether you wish to perform
confirmation print and complete the setup.
Media feed adjustment
Steps
1. Select "PF Adjust 1: Initial Print".
・ "Feed Length: 250 mm" is displayed on the front panel.
2. After the initial adjustment printing, cut the media.
・ Measure the distance between the "
ruler.
3. Refer to Chapter 1 "Media feed adjustment steps" and select "PF Adjust 2: Initial
Change" on the front panel.
4. Use or on the front panel and enter the measured value in Step 2.
・ Tap [Enter] to save the initial adjustment value.
5. Use or on the front panel to select "PF Adjust 3: Confirm Print".
・ "Feed Length: 250 mm" is displayed on the front panel.
6. After the confirmation adjustment printing, cut the media.
・ Measure the distance between the "
using a ruler. Then, confirm that the distance matches the feeding length when
printing.
・ If the distance does not match the feeding length, follow the procedure from Step
1 to Step 5 and readjust.
・ If the distance matches the feeding length, proceed to Step 7.
7. Refer to Chapter 1 "Media feed adjustment steps" and select "PF Adjust 4: Micro
Print" on the front panel.
・ Check the pattern and micro adjustment value. In the pattern, look for a place
that has least white lines or overlapping in images.
The number printed below the adequate pattern is the micro adjustment value.
8. Enter the micro adjustment value according to the printing result in Step 7.
When you know the adjustment value
(when changing the media or for similar operations)
1. Enter the adjustment value for "PF Adjust 5: Micro Change".
2. Select whether you wish to print a confirm pattern and complete the setup.
Page. 50
To Table of Contents
cf. Operation Manual(Rev.01-p.69)
" in the initial adjustment print using a
" in the confirmation adjustment print
CONFIDENTIAL