MUTOH XpertJet XPJ-1641SR Training Manual page 27

5. Unpacking and Initial Setup
5.4. Connecting Power and Network (2/2)
Connecting Power and Network
Connect Power Cords and Ethernet Cable
[3] Insert the tip of the cable tie into the hole on the printer to attach it.
[4] Use the cable tie to secure the Ethernet cable to the printer.
[3] Plug two power cords into the wall outlets respectively.
To plug into one wall outlet with two or more jacks, check that the total current
does not exceed the maximum capacity of the wall outlet.
If exceeded, connect one of the two power plugs into another wall outlet.
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.14)
Page.
Connect Power Cords and Ethernet Cable
Electric shock hazard.
This printer has two power cords.
To unplug from the wall outlet, make sure to unplug both of them.
27
To Table of Contents
cf. Startup Guide(Rev.01-p.14)
CONFIDENTIAL