Head Cleaning; Performing Head Cleaning; Performing Nozzle Check - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance

11.5. Head cleaning (1/2)

Cleaning
Head cleaning
If you find missing or thin lines on your print or nozzle check print, perform head
cleaning.
Following cleaning modes are available:
Short cleaning Consumes less ink than Normal cleaning.
Normal cleaning If nozzle missing is found on the nozzle check print,
perform Normal cleaning.
Long cleaning If nozzle missing still persists after Normal cleaning,
perform Long cleaning.
It consumes more ink than Normal cleaning.
Little Charge Little Charge gives higher cleaning than Long cleaning,
but consumes large amount of ink.
Initial Charge Initial Charge offers more powerful cleaning than
Little Charge, but consumes large amount of ink.
When you perform "Little Charge" or "Initial Charge",
・ Do not power off the printer.
・ Do not disconnect the power cords.
・ Do not open the front cover and maintenance cover during cleaning.
・ Do not release the pressure rollers.
・ Do not remove ink bag cases and S/C cards from the printer.
・ Be sure that remaining ink in the ink bag is enough to perform cleaning.
If cleaning is interrupted, it may consume more amount of ink.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.117)
Head cleaning
1.

Performing Head cleaning

[1]
[2]
[3] Run a nozzle check.
2.

Performing Nozzle check (1/2)

[1]
[2]
Page. 107
To Table of Contents
cf. Operation Manual(Rev.01-p.118)
Tap .
Use or to choose the cleaning mode.
Tap [Enter].
・ The printer will start cleaning.
Tap .
Tap [Enter].
・ The printer will print the nozzle check pattern.
CONFIDENTIAL