Cutting Media - MUTOH XpertJet XPJ-1641SR Training Manual

7. Carriage
7.2. Changing the Head Height (1/1)
Changing the Head Height
◆ XPJ-1641SR
◆ XPJ-1682SR
If you use a roll media that warps easily or perform high-density print, the print head
may contact the media while printing.
If you experience such problem, try changing the head height higher.
After you change the head height, make sure to perform the print quality calibration.
Do not open Front cover and change the head height during printing.
Print quality cannot be guaranteed.
Low
Use the head height adjustment lever (orange) to change
the head height to "Mid" or "High".
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.40)
Middle High
Page.

7.3. Cutting media (1/2)

Cutting media
◆ XPJ-1641SR
◆ XPJ-1682SR
[1]
[2]
・ If the front edge of a new roll media is not straight, cut it before printing.
・ When the media detection is set to "Off", the printer does not cut the media
automatically.
→ "Setup 4: Media Initial"
・ When the Output mode menu is set to "Auto Cut", the printer cuts the media
automatically after printing.
→ "Setup 6: Output Mode"
・ The cutter blade is consumable parts. Replace it when needed.
61
To Table of Contents
cf. Operation Manual(Rev.01-p.46)
Check that the job has been printed.
Tap [Cancel].
・
Tap [Enter].
The printer will advance the media for the
・
bottom margin and will cut it.
CONFIDENTIAL