Origin; Cut Pressure Menu - MUTOH XpertJet XPJ-1641SR Training Manual

10. Advanced Operations
10.2. Menu 1: Setup (4/12)
Menu 1: Setup
Setup 7: Method of Cut
Sets the media cutting operation after printing.
Setting values
・ When the media detection is set to "Off", the media cannot be cut automatically.
・ Some media may not be cut (cannot be cut at all or cannot be cut finely).
In such a case, set the "Output Mode menu" to "Off" and cut the media manually.

Cut Pressure menu

Sets the media cutting pressure for the cutting
operation.
Setting values
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.79)
Cut with fewer steps than "Single Cut - 3
steps".
Suitable for media with narrow width.
Normal cutting method.
This is the initially set value.
Set when unable to cut with "Single Cut - 2
steps"
Suitable for media with narrow width.
Set when unable to cut with "Single Cut - 3
steps".
Cut the media at low pressure.
Suitable for thin media or if the "High" pressure
setting is too strong.
Normal cutting pressure.
This is the initially set value.
Setup 8: Origin
Setting values
The arrow mark on the origin label
shows the current print start position
in CR direction.
・ Depending on the set value of the side margin, the maximum set value of Y (print
head transferring distance) decreases.
・ The right side margin will be the following sum depending on the setting.
Y of Origin menu + 8 mm (when the spitting is set to On Media) + Value set in Side
Margin menu.
Page. 87
To Table of Contents
cf. Operation Manual(Rev.01-p.80)
Sets the print start position (origin) on the media.
If you want to change the print start position to print
an image on the blank space of the media, use this
menu.
・ / : Change the print start position (origin) in
the PF (media feeding) direction.
・ / ：Change the print start position (origin) in
the CR (carriage traveling) direction.
・ Tap [Enter] to confirm the setting.
PF (media feeding direction):
-15,000 mm to 15,000 mm
CR (carriage traveling direction)
0 mm to 1,405 mm (maximum setting range
varies by width of media being loaded).
When the message on the left appears, tap
[Enter] to end the origin settings.
CONFIDENTIAL