Test Printing; Load A Roll Media Into The Printer - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.5. Printer Initial Setup (7/7)
Printer Initial Setup
Step 4 Initial Cleaning - Initial Ink Charging
2. Perform initial ink charging (4/4)
DO NOT attempt the following actions during ink charging:
・ Power off the printer.
・ Disconnect the power cord.
・ Open the front cover.
・ Open the maintenance cover.
・ Release the pressure rollers.
[9]
CSTM-XPJ16xxSR(E)_1.00
cf. Startup Guide(Rev.01-p.27)
Once the ink has been filled, the message on the
left will appear on the panel.
・ The ink charging is complete.

5.6. Test Printing (1/5)

Test printing

Load a roll media into the printer

Follow the steps below to load a media into the printer.
Depending on the size of media, two or more people are required.
Items Required:
・ Roll media
・ Media flange: ×2
1. Attach flanges to the media
[1] (If you are using 2-inch core roll media), remove
the 3-inch adapter from the media flange.
①: Pull two tabs on the adapter outward, then
remove it from the flange.
②: Pull three tabs on the adapter outward, then
remove it from the flange.
・ If adaptor cannot be removed, turn the handle on the flange anti-clockwise to
loose (see Step 2), then remove it.
・ If you are using 3-inch core roll media, skip this step.
[2] Push the media flange (×2) into the both ends of
the media core.
・ Before inserting, twist the handle on the flange
anticlockwise to unlock it.
[3] Twist the handle clockwise to lock the flange.
Check that the flange is firmly locked.
If not, the media can be removed from the
flanges, affecting the print quality.
Page. 34
To Table of Contents
cf. Startup Guide(Rev.01-p.28)
CONFIDENTIAL