Performing Initial Charging After Head Cleaning - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance
11.15. Long-term storage (3/4)
Moving or transporting the printer
Long-term storage
1. Step (5/5)
[13]

Performing initial charging after head cleaning

1. Step (1/4)
[1]
[2]
[3]
If you need to perform a head cleaning and "Wash retry? No" is displayed, tap the
key to change the display to "Wash retry? Yes" and tap [Enter].
After that, follow the instructions displayed on the front panel.
When cleaning is complete, "Insert InkBags" is displayed. Proceed to step 4 in this
section.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.142)
Long press the Power button.
・ This product starts its powering off operations.
・ When the message "Power Off" appears on the
panel, release the Power button.
・ The Power LED lights off.
Long press the Power button.
・ The Power LED (above the Power button) lights
up.
・ This product starts its initialization operations.
Once the Power LED lights up, release the Power
button.
When the message to the left is displayed, tap
[Enter].
When the message to the left is displayed, tap
[Enter].
Performing initial charging after head cleaning
1. Step (2/4)
[4]
[5]
[6]
Page. 123
To Table of Contents
cf. Operation Manual(Rev.01-p.143)
The message on the left will appear.
Make sure you agitate the ink bag after you
prepare it.
・ Face the ink spout side upwards for 3 seconds.
・ Invert it and count for 3 seconds.
・ Repeat that 3 times.
Be sure to use new ink bags.
If a half-used ink bag does not have enough
ink, it will run out of ink during initial ink
charging and will consume more ink.
Put the ink bag into the case.
Close the ink bag case.
Make sure the spout of ink bag is properly
fitted into the groove in the case.
If not fitted, the printer cannot correctly
detect ink bag.
Close all the latches (×4) of the case properly
Check that all the latches (×4) are closed.
If not, it may cause ink spillage.
CONFIDENTIAL