12. Engineer Maintenance
12.1. Removing Covers (9/9)
cf. Maintenance Manual (XPJ-1641SR:Rev.00-3.11.3./XPJ-1682SR:Rev.00-3.11.3.)
Paper Guide R
Preparation:
・
Phillips Screwdriver No.2
Screws:
・
S Tight Cup M3x6 (x12)
・
Round Head Screw with Split Washer M4x8 (x10)
[1] Remove Roll Media holder(s).
[2] Remove lid(s).
・
Lid (x3)
・
S Tight Cup M3x6 (x12)
[3] Remove cables in the connector.
・
Preheater Cable Assy(2)
・
Pre_Thermistor Relay Assy(2)
[4] Remove screw(s).
[5] Remove paper guide R.
[6] To Assemble unit, reverse the removal procedure
CSTM-XPJ16xxSR(E)_1.00
cf. Maintenance Manual (XPJ-1641SR:Rev.00-3.8.2./XPJ-1682SR:Rev.00-3.8.2.)
Manual Release of Carriage Lock
[1] Remove side cover R
[2] Push carriage lock in the arrow direction.
[2]
cf. Maintenance Manual (XPJ-1641SR:Rev.00-3.8.3./XPJ-1682SR:Rev.00-3.8.3.)
CR Cover
Preparation:
・
Phillips Screwdriver No.2
Screws:
[4]
・
Round Head Screw with Split Washer M3x6 (x2)
[1] Remove side cover R.
[2] Release carriage lock manually.
[3] Remove screw(s).
[4] Remove CR cover.
[5] To Assemble unit, reverse the removal procedure.
cf. Maintenance Manual (XPJ-1641SR:Rev.00-3.8.4./XPJ-1682SR:Rev.00-3.8.4.)
CR BoardCover
Preparation:
・
Phillips Screwdriver No.2
Screws:
・
Round Head Screw with Split Washer M3x6 (x3)
[1] Remove upper tray.
[2] Remove screw(s).
[3] Remove CR board cover.
[4] To Assemble unit, reverse the removal procedure.
Page.
133
To Table of Contents
[3]
[3]
[2]
CONFIDENTIAL