Replacing The Waste Liquid Tank - MUTOH Viper TX Operation Instructions Manual

5.2.2 Replacing the waste liquid tank

5.2.2.1 Replacement Time
Replace the waste liquid tank under the following conditions.
a. When the waste liquid tank is nearly full.
•
Following message is displayed on the operation panel.
•
Printing continues.
•
Prepare a new waste liquid tank before the waste liquid tank becomes full.
5.2.2.2 Replacement Procedures
Step 1 :
Check the following if the power of the printer is ON.
• Printer is not printing.
• Operation panel is in normal status.
• Fabric setting light on the operation panel is off.
Step 2 :
Follow "Menu setup on the operation panel"
Step 3 :
Open the cap of the waste liquid tank.
•
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid to leak out
and damage the printer.
Step 4 :
Remove the waste liquid tank from the tank tray of the stand.
•
Put the used waste liquid tank in a plastic bag and follow the local regulations when disposing.
Step 5 :
Open the cap of a new waste liquid tank and put the tank to the printer.
Step 6 :
Press the [ENTER] key on the operation panel.
•
The printer returns to the normal status by pressing the [CANCEL] key
Downloaded From ManualsPrinter.com Manuals
→
Warning WastInkTank
Feed
Cancel
User1
* TankChg. *
No
Changed wasted ink tank?
ENTER or CANCEL
Caution
Notes
* SetupMenu *
F1 →
H.Unlock.
F3 →
TankChg.
Ready to Print
Heaters
Feed
User1
Viper TX – Operation Instructions
Cleaning
LeverUp
Om
← F2
Yes
(1/1)
← F2
WiperClean
← F4
TubingFlush
(6/7)
Cleaning
LeverUp
xxxm
67
AP-75710, Rev. 1.1, 09/01/2008