Data Corrupt Or Stale; Measurement Data Is Not Available - Keysight X-Series Manual

Instrument Messages
Event Messages
Err# Message
-224
Illegal parameter
value;This model is
always AC coupled
-225
Out of memory
-225
Out of memory;
Insufficient resources
to load Mode <mode
name>
-225
Out of memory;
Insufficient resources
to load Mode <mode
name>. Paging file
size too small
-225
Out of memory; Memory
limit caused Data
Acquisition to be
truncated
-226
List not same length
-230
Data corrupt or stale;
-230
Data corrupt or stale;
Measurement data is
not available
-230
Data corrupt or stale;
Trace contains no
data.
-230
Data corrupt or stale;
Unable to load state
from file
-231
Data questionable
-232
Invalid format
-232
Invalid format; Map
information not loaded
Instrument Messages
Verbose/Correction Information
You can't set DC coupling in this analyzer
There is not enough memory to perform the requested operation.
If you attempt to load a mode via SCPI that will exceed memory
capacity, the Mode does not load and this message is returned. "mode
name" is the SCPI parameter for the Mode in question, for example, SA
for Spectrum Analyzer Mode. You can free up resources in the System,
Power On, Configure Applications menu
If you attempt to load a mode via SCPI that will exceed memory
capacity, the Mode does not load and this message is returned. "mode
name" is the SCPI parameter for the Mode in question, for example, SA
for Spectrum Analyzer Mode. You can free up resources in the System,
Power On, Configure Applications menu.
Also, paging file size is unexpectedly small. Consider increasing the
paging file size or cleaning up unnecessary files from system drive.
You are using the LIST structure, but have individual lists that are not
the same lengths.
A legal data element was found, but it could not be used because the
data format or the data structure was not correct. Maybe a new
measurement had been started but had not completed.
Measurement data not available. The measurement that you are trying
to get data from must be the current active measurement. Maybe you
have not initiated the measurement, or it has not completed all the
sweeps/averages needed.
Trace cannot be displayed because currently there is no data assigned
to it. Use the functions under the Trace menu, or load a previously
saved trace, to assign data to the trace.
There is something wrong with the state data in the desired file. Maybe
the file is corrupt, or it is from an instrument/version that is not
recognized by the current instrument.
Indicates that the measurement accuracy is suspect
A data element was found but it could not be used because the data
format or the data structure was not correct.
Instrument failed to load the burst mapping information from the
selected file.
76