Carrier(S) Incorrect Or Missing - Keysight X-Series Manual

Instrument Messages
Condition Messages
Err# Bit in
Status
Register
209 3
211 4
213 5
213 5
213 5
215 6
215 6
215 6
215 6
215 6
215 6
Instrument Messages
Message
Timing Error:No time
ref pilot burst
Carrier(s) incorrect or
missing
Freq Out of Range
Freq Out of Range;
System input (IF)
Freq Out of Range;
External LO
Sync Error
Sync Error;No pilot
burst
Sync Error;Sync code
not found
Sync Error;No freq ref
pilot burst
Sync Error;Midamble
sync fail
Sync Error;Preamble
length zero
Error or More Information
Warning
E The pilot burst used for time reference is not
active.
E In the PSA, this error was reported as one of
the following error numbers: 10165, 10173,
10178, 10419, 10421, 10535, 10560, 10642,
10648, 10650, 10960
E
E One or more system input frequencies are out
of range. If using a frequency list, check that
all entries are valid for current measurement
mode.
E One or more external LO frequencies are out
of range. Check that the LO frequency limits
are set correctly and check the entered
measurement frequencies and measurement
mode.
E W-CDMA: Cannot sync DPCCH pilot.
Cannot synchronize measurement with
DPCCH pilot for Power Control measurement,
because the pilot signal cannot be found.
Make sure DPCCH is present in the W-CDMA
uplink signal, and that the slot format and
scramble code are set correctly.
E There is no Pilot burst detected.
E Synchronization code is not found in the
measured time slot.
E The pilot burst used for frequency reference is
not active.
E Failed to find the uplink slot, which caused
the synchronization with the midamble to fail.
E Burst type is "Data" or "Preamble" and the
measurement cannot find a Preamble
100