To 399, Uncalibrated Integrity - Keysight X-Series Manual

Instrument Messages
Condition Messages
Err# Bit in
Status
Register
217 7
219 8
221 9
221 9
221 9
223 10
225 11
227 12
229 13
231 14

301 to 399, Uncalibrated Integrity

This series of errors corresponds to the bits in the
STATus:QUEStionable:INTegrity:UNCalibrated
Status Register System" on page
the corresponding bit in that register.
An event with the number shown in the table means the condition has been
detected. When the condition is cleared, an event with the number plus 1000
is generated. These error numbers can be viewed in the Show Errors screen,
along with the DETECTED and CLEARED indicators.
For example, error 301 indicates a Meas Uncal condition has been detected,
error 1301 indicates that failure has been cleared.
Instrument Messages
Message
Demod Error;Acq Time
too short
Signal Too Noisy
Slot Error
Slot error;No active
slot found
Slot Error; No idle
slot found
unused
unused
unused
unused
unused
Error or More Information
Warning
E For Bluetooth, the detected packet type
doesn't match the captured packet type
because the payload start, end or data could
not be found.
E GSM & EDGE: In a GSM measurement,
indicates that a burst could not be found in a
signal that appears noisy.
In the PSA, this error was reported as one of
the following error numbers: 10702, 10824,
10906, 10930, 13024, 10626, 111
E
E No valid active slot found in captured data, or
no active slot found in captured interval.
Synchronization may succeed and pilot found
when this message is issued, but no results
are included in peak/average calculation.
E No valid idle slot found in captured data, or no
idle slot found in captured interval.
Synchronization may succeed and pilot found
when this message is issued, but no results
are included in peak/average calculation.
E
E
E
E
E
sub-register (see
116). The second column in the table shows
"X-Series
102