All Ranges Are Off. Turn On At Least A Range - Keysight X-Series Manual

Instrument Messages
Event Messages
–26x
–27x
–28x
–29x
Err# Message
-200
All ranges are off.
Turn on at least a
range
-200
At Full Zoom
-200
Cannot move marker
outside of displayed
frequency span
-200
Disturbance List is
Empty
-200
Disturbance selected
is not in the
Disturbance List
-200
Execution Error
-200
Execution error;
Carrier frequency
outside device's
transmit band
-200
Execution Error; Data
in Correction File
Range x File x does
not cover the range
frequency span
-200
Execution error;
Invalid GSM burst
timing
-200
Execution error;
Invalid IP address
-200
Execution error;
Invalid Marker Trace.
-200
Execution Error; No
peak found.
Instrument Messages
Expression data error
Macro error
Program error (a downloaded program-related execution error)
Memory use error
Verbose/Correction Information
There are no range turn on in scan table. You need to turn on at least a
range to initiate a scan.
Marker Zoom is not available as it has reached full zoom.
Meters frequency is out of displayed frequency range. You must
extend the displayed range from the scan table if you wish to set the
selected marker to this frequency on the graph display.
Cannot perform the selected function because the disturbance list
contains no data.
The user has selected an invalid disturbance (one that is not in the list)
A program execution error has occurred. The exact problem cannot be
specifically identified.
The entered channel/carrier frequency is not within the range of your
current mode setup selection of standard and device.
You have tried to use a correction file that does not cover the
frequency span of the correction range. Please fix the file or select
another file.
A GSM-like burst was acquired, but its timing is not valid. Ensure the
correct Burst Type has been selected.
The IP address supplied is either not valid or does not belong to a
compatible Signal Generator. Please check the IP address and
instrument connection and try again.
Cannot place markers on the reference trace, because the reference
trace is currently turned off or has no data.
No signal peak was found within the defined parameters of the search.
(Note: for ESA/PSA compatibility, the Swept SA measurement uses
780 for this error number; all other measurements use -220)
68