Signals Deleted - Keysight X-Series Manual

Instrument Messages
Advisory Messages
Message

Signals deleted

Sweep Points/Span is <
minimum. Results may be
inaccurate.
Sweep Setup is not
available in Zero Span
Sync is RF Ampl (not
Training Sequence). Bits
are not accurate.
Trace file saved.
Use Gate View Sweep Time in
the Gate menu.
User Cal valid. Apply Cal
from Meas Setup menu
Instrument Messages
Description/Correction Information
The signals in the signal list were successfully deleted.
The sweep point to span ratio is below the minimum required to ensure the bucket
ratio is large enough to test DVB-T masks
Zero span is a display at a single frequency, so there is no "sweeping" to set up.
The trace saving operation was successful.
When in Gate View you use Gate View Sweep Time, rather than Sweep Time, to
control the Gate View window
The measurement setup has changed such that the current cal data can be applied
to the results. To apply the cal, press Meas Setup/Cal Setup/Apply Calibration. A
new cal can be performed if required.
41