Settings Conflict; Normalize Is Not Available While Demod View Is On - Keysight X-Series Manual

Instrument Messages
Event Messages
Err# Message
-221
Settings conflict;
Normalize is not
available while Demod
View is on
-221
Settings conflict;
Normalize is not
available while Trace
Math is on
-221
Settings conflict; not
available with Global EMC
Standard
-221
Settings conflict; Only
active Antenna Unit
available; no other Y axis
units
-221
Settings conflict; Option
not available
-221
Settings conflict; Output
Port is not available
while occupied by Input
-221
Settings conflict; Output
Port is not available
while occupied by Input of
incompatible frequency
-221
Settings conflict; Output
Port is not available
while port bank is
occupied by Input
-221
Settings conflict; Param
only available when DUT is
a freq converter
-221
Settings conflict; Param
only available when
External LO Mode is Swept
-221
Settings conflict; Param
only available when
External LO Mode is Fixed
-221
Settings conflict; Param
only available when
Frequency Mode is Fixed
Instrument Messages
Verbose/Correction Information
The normalization (correction) function cannot be used if you are
using the Demod View.
The Normalize function works by doing trace manipulation. So if
trace math is on you cannot turn on normalization.
You can't use this function. To enable this function, turn off Global
EMC Standards.
When a correction with antenna units is turned on, the only Y-Axis
units you can have are those that match the Antenna Unit. Turn off
the Correction or the Antenna Unit under Input/Output,
Corrections
You have attempted to perform an action for which a required
option is not installed
The desired destination for the Output Port is already occupied by
the Input Port. First set the Input to a different port or None.
You attempted to select a port as an Output for a mmWave
Transceiver of a given frequency range, but the Input is already
configured for a mmWave Transceiver of an incompatible
frequency range. First set the Input Port to None and then select
an Output port.
The desired destination port bank for the Output Port is already
occupied by the Input Port. First set the Input to a different port
bank or None.
SCPI only message. The sideband and freq context parameters
are only available when a freq conversion setup is in use. Change
setup to contain a freq conversion to use these parameters.
SCPI only message. This parameter is only available when the LO
mode is set to Swept. Change the LO Mode to Swept.
SCPI only message. This parameter is only available when the LO
mode is set to Fixed. Change the Freq Mode to Fixed.
SCPI only message. This parameter is only available when the
Freq mode is set to Fixed. Change the Freq Mode to Fixed.
60