To 64, Calibration Needed Or Failed - Keysight X-Series Manual

Instrument Messages
Condition Messages
An event with the number shown in the table means the condition has been
detected. When the condition is cleared, an event with the number plus 1000
is generated. These numbers can be viewed in the Show Errors screen, along
with the DETECTED and CLEARED indicators.
For example, message 6 indicates that the "RF Alignment being skipped"
condition has been detected, and message 1006 indicates that failure has
been cleared.
This register is summarized as bit 11 of the
STATus:QUEStionable:CALibration
64, Calibration Needed or Failed" on page
Err# Bit in Message
status
register
6 0
Align RF Skipped
8 1 unused
10 2 unused
12 3 unused
14 4 unused
16 5 unused
18 6 unused
20 7 unused
22 8 unused
24 9 unused
26 10 unused
28 11 unused
30 12 unused
32 13 unused
34 14 unused

36 to 64, Calibration Needed or Failed

This series of messages corresponds to the bits in the
STATus:QUEStionable:CALibration
System" on page
corresponding bit in that register.
Instrument Messages
register, as described in section
Error or More Information
Warning
W
register (see
116). The second column in the table shows the
88.
"X-Series Status Register
"36 to
88