Mitsubishi Electric MDS-E Series Instruction Manual page 92

MDS-E/EH Series Instruction Manual
2 Wiring and Connection
(3) Cable connection procedure
(a) Processing of power insulator
Since the strip length of wire depends on the types of wire, etc., decide the optimum length according to the
machining state.
Retwist and straighten the core as shown below.
(4) Insertion of the cable
Insert the connection lever as shown in the following illustration, and push it down to open the spring.
Keep the connection lever pushed down and insert the stripped wire to the insert hole. Confirm the insert depth so
that the wire insulator is not caught.
Release the connection lever to fix the wire. Pulling the wire for confirming the secure connection.
Sheath
Strip length
Unraveling or
bending of core
1) Push the connection lever down.
3) Release the connection lever to fix the wire.
2) Insert the wire.
61
Core
Make sure to retwist
and straighten the core
IB-1501229-F