Mitsubishi Electric MDS-E Series Instruction Manual page 498

MDS-E/EH Series Instruction Manual
10 Appx. 1: Cable and Connector Assembly
Angle back shell
[1] Fix the 2 surface width of the angle back shell on the tightening guide.
[2] Set the back shell wrench adjusting to the 2 surface width of the back shell coupling.
[3] With the wrench, tighten the back shell coupling to the angle back shell.
Recommended tightening torque: 4 to 5N.m
(Note 1) When setting the work to the wrench, adjust it to the 2 surface width.
To remove, take the reverse steps.
(Note 2) To change the back shell angle, adjust the toothing position of the plug shell and back shell.
(Note 3) Manufactured by DDK
Contact: Fujikura Ltd. http://www.fujikura.co.jp/eng/
Tighten
Angle back shell
Torque wrench
* Referential dimensions for back
shell tightening guide
* Recommendation:
Tightening guide
(357J-52658T)
(8) Insert a busing and a cable clamp
Insert the bushing and the cable clamp in the back shell.
Cable clamp
Cable
(Note) After the Bushing insert, confirm that cable position should be inside of Bushing.
(9) Tightening a clamp nut
Straight back shell
[1] Temporarily tighten the clamp nut on the straight back shell.
*To prevent the loosening, it is recommended to coat the straight back shell with adhesive.
Recommended adhesive: 1401B (Three Bond Co., Ltd.)
[2] Fix the 2 surface width of the straight back shell on the tightening guide.
[3] With the wrench, tighten the clamp nut on the straight back shell.
Recommended tightening torque: 4 to 5N•m
(Note 1) When setting the work to the wrench, adjust the 2 surface width.
To remove, take the reverse steps.
(Note 2) Manufactured by DDK
Contact: Fujikura Ltd. http://www.fujikura.co.jp/eng/
Set
19
Back shell
wrench
coupling
Set
15
(Back shell width)
● Recommended jigs and tools : Back shell wrench (357J-51333T)
* Recommended tightening guide: (357J-53402T) (Note 3)
Bushing
Back shell
Insert
Tightening guide
Angle back shell
Bit (357J-51344T)
Torque wrench (CL6N x 8D,Tonichi Mfg.)
Bushing
Cable clamp
Cable
Insert
467
(Note 3)
Back shell
IB-1501229-F