Mitsubishi Electric MDS-E Series Instruction Manual page 548

Date of revision Manual No.
Sep. 2018 IB(NA)1501229-D
Jul. 2019 IB(NA)1501229-E
Sep. 2019 IB(NA)1501229-F
- "Installation of Tool Spindle Motor" was revised.
- "Installation Direction and Clearance" and "Heating Value" in "Installation of
the Drive Unit" were revised.
- "Spindle Side PLG Serial Output Encoder (TS5690, MU1606 Series)" was
revised.
- "Twin-head Magnetic Encoder (MBA405W, MBE405W Series)" was deleted.
- "Wiring and Connection" was revised.
- "Part System Connection Diagram" was revised.
- "Main Circuit Terminal Block/Control Circuit Connector" was revised.
- "NC and Drive Unit Connection" was revised.
- "Motor and Encoder Connection" was revised.
- "Connection of Power Supply" and "Wiring of the Motor Brake" were revised.
- "Safety Function" was revised.
- "STO (Safe Torque Off) Function" was revised.
- "SBC (Safe Brake Control) Function" was revised.
- "Wiring of the motor magnetic brake" was added.
- "Initial Setup" was revised.
- "Setting the Initial Parameters for the Servo Drive Unit" was revised.
- "Setting of Servo Specification Parameters", "Setting of Machine Side
Encoder" and "Setting of Distance-coded Reference Scale" were revised.
- "List of Standard Parameters for Each Servo Motor" was revised.
- "Servo Parameters" was revised.
- "Setting the Initial Parameters for the Spindle Drive Unit" was revised.
- "List of Standard Parameters for Each Spindle Motor" was revised.
- "Spindle Specification Parameters" was deleted.
- "Spindle Parameters" was revised.
- "Spindle-type Servo Parameters" was deleted.
- The following graphs were added in "Speed Loop Gain".
HG46, HG56, HG96, HG-154(V3-40), HG-H1502
- "OMR-FF Function" was revised.
- "Characteristics Improvement" was revised.
- "Full-closed Torsion Compensation Function" was added.
- "Settings for Emergency Stop" was revised.
- "Protective Functions" was revised.
- "Adjustment Procedures for Each Control" was revised.
- "Settings for Emergency Stop" was revised.
- "Spindle Control Signal" was revised.
- "List of Alarms" was revised.
- "List of Warnings" was revised.
- "Troubleshooting" was revised.
- "Maintenance" was revised.
- "Service Parts" was revised.
- "Replacing the Battery" was revised.
- "Wiring of Deceleration and Stop Function at Power Failure" was revised.
- "Output Data Settings" was revised.
- "Emergency Stop Observation" was revised.
- "Compliance to EC Directives" was revised.
- "Ferrite Core" was revised.
- "Surge Absorber" was revised.
- Miswrite is corrected.
- "Wiring of the Motor Magnetic Brake" was revised.
- MDS-EH-V2-160 was added.
- SJ-DN Series spindle motors were added.
- The following spindle motor was added.
SJ-DG15/120-02T-K
- "Precautions for Safety" was revised.
- Function Specifications List was revised.
Revision details