Mitsubishi Electric MDS-E Series Instruction Manual page 276

MDS-E/EH Series Instruction Manual
4 Setup
(PR) #13236 SP236 WIH
Set the delay time constant from the thermistor temperature to the control compensation amount.
When "0" is set, the delay time constant is disabled.
When not using, or when using an IPM spindle motor, set to "0".
---Setting range---
0 to 150 (min)
(PR) #13237 SP237 TCF
Set the filter for the torque command.
The standard value is "500".
---Setting range---
0 to 5000 (rad/s)
(PR) #13238- SP238-SP240
13240
Not used. Set to "0".
(PR) #13241- SP241-SP256
13256
This is automatically set by the NC system.
Temperature compensation time constant
Torque command filter
245 IB-1501229-F