Mitsubishi Electric MDS-E Series Instruction Manual page 269

MDS-E/EH Series Instruction Manual
4 Setup
(PR) #13143- SP143-SP160
13160
Set the unique constants for the spindle motor. (High-speed coil)
The setting value is determined by the motor's mechanical and electrical characteristics and specifications,
so normally set the value given in the spindle parameter list.
(PR) #13161- SP161-SP192
13192
Set the unique constants for the spindle motor. (Low-speed coil)
The setting value is determined by the motor's mechanical and electrical characteristics and specifications,
so normally set the value given in the spindle parameter list.
#13193 SP193 LMR
Set the standard output to be displayed as 100% in load meter using the short-time rated output ratio.
To display the continuous rated output as 100%, set as follows.
Continuous rated output/Short-time rated output × 100
When "0" is set, normal display will be applied.
---Setting range---
0 to 100 (%)
#13194 SP194 LMN
Set the base speed of the standard output to be displayed as 100% in load meter.
When "0" is set, the base speed of the short-time rated output will be applied.
---Setting range---
0 to 32767 (r/min)
#13195 SP195 LMRL
Set the standard output to be displayed as 100% in load meter using the short-time rated output ratio.
To display the continuous rated output as 100%, set as follows.
Continuous rated output/Short-time rated output × 100
When "0" is set, normal display will be applied.
---Setting range---
0 to 100 (%)
#13196 SP196 LMNL
Set the base speed of the standard output to be displayed as 100% in load meter.
When "0" is set, the base speed of the short-time rated output will be applied.
---Setting range---
0 to 32767 (r/min)
#13197- SP197-SP198
13198
Not used. Set to "0".
IB-1501229-F
Change magnification for load meter standard output
(High-speed coil)
Base speed for load meter standard output (High-speed
coil)
Change magnification for load meter standard output
(Low-speed coil)
Base speed for load meter standard output (Low-speed
coil)
238