Mitsubishi Electric MDS-E Series Instruction Manual page 497

MDS-E/EH Series Instruction Manual
10 Appx. 1: Cable and Connector Assembly
(6) Assembling a back shell
[1] To prevent the back shell from loosening, it is recommended to coat 2 threads of the circumference of the back
shell with adhesive.
Recommended adhesive: 1401B (Three Bond Co., Ltd.)
[2] Rotate the back shell coupling of the connector and temporarily tighten the back shell.
* When tightening temporarily, match the concavity and convexity
of the plug shell with those of the back shell.
(You can confirm the correct connection of concavity and
convexity waving lightly back shell just before inserting to BS
coupling.)
(7) Tightening a back shell
Straight back shell
[1] Fix the 2 surface width of the straight back shell on the tightening guide.
[2] Set the tightening wrench adjusting to the back shell coupling.
[3] With the wrench, tighten the back shell coupling to the straight back shell.
Recommended tightening torque: 4 to 5N•m
(Note 1) When setting the work to the wrench, adjust it to the 2 surface width.
To remove, take the reverse steps.
(Note 2) Manufactured by DDK
Contact: Fujikura Ltd. http://www.fujikura.co.jp/eng/
●
* Recommended tightening guide: (357J-53234T) (Note 2)
IB-1501229-F
Adhesive (to be coated to 2
Back shell threads of the circumference)
Insert
Back shell coupling
Back shell
Temporarily
tighten Back shell coupling
Back shell
Back shell
coupling
Set
Tightening
guide
Back shell
wrench
Back shell
Tighten
wrench
Recommended jigs and tools :
Back shell wrench (357J-51333T) (Note 2)
Bit (357J-51344T)
Torque wrench (CL6N x 8D,Tonichi Mfg.)
Angle back shell
Adhesive (to be coated to 2
threads of the circumference)
Insert
Back shell coupling
Temporarily tighten
Tightening guide
19
* Referential dimensions for
back shell tightening guide
(Back shell width)
15
Thickness:
10
* Recommendation:
Tightening guide
(357J-53234T)
466
Back shell coupling
Plug shell concavity Back shell concavity
and convexity and convexity