Mitsubishi Electric MDS-E Series Instruction Manual page 398

MDS-E/EH Series Instruction Manual
6 Spindle Adjustment
(6) Spindle control input 6
Name
Spindle control input 6
bit0. OMR-FF control request (OMRFF)
[1] The OMR-FF control which determines the tracking ability to the position command by using scale model
gain is selected with OMRFF=1.
[2] The tracking ability to the position command is determined by using conventional position loop gain with
OMRFF=0.
bit8. Drivers communication control request (DD1)
[1] The high-speed synchronous tapping control which allows data communication between drive units is
selected with DD1=1.
[2] The normal synchronous tapping is selected with DD1=0.
(Note) The bits other than those above are used for maintenance.
Details
F E D C B A 9 8 7
DD1
Details
bit
0
OMRFF OMR-FF control request
-
1
(For maintenance)
2 -
(For maintenance)
3 -
(For maintenance)
4 -
(For maintenance)
- (For maintenance)
5
(For maintenance)
6 -
(For maintenance)
7 -
DD1 Drivers communication control request
8
9 - (For maintenance)
A - (For maintenance)
(For maintenance)
B -
(For maintenance)
C -
(For maintenance)
D -
(For maintenance)
E -
(For maintenance)
F -
367
6 5 4 3 2 1 0
OMRFF
IB-1501229-F