Procedure 10-21: 1+1 Protection Test - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

Network establishment and testing
...................................................................................................................................................................................................................................

Procedure 10-21: 1+1 protection test

Purpose
This test provides a scenario for testing the O
Creation of paths
Two paths must be created for a 1+1 protection. Proceed as follows to create the first path
between E-A, E-D and E-C, and the second (protection) path between E-A, E-D,
E-B and E-C:
...................................................................................................................................................................................................
Select Configuration → Create New Path from the map's menu bar.
1
Result:
...................................................................................................................................................................................................
Select the signal rate (bandwidth) which shall be used via the Signal Rate list.
2
Important! Make sure that the EDGE ports to which the analyzers are connected are
configured to the same signal rate as the analyzers!
...................................................................................................................................................................................................
Select in the Source group box via the Node IP list the SC IP address of E-A (see
3
section
SC nodes" (p.
...................................................................................................................................................................................................
Select in the Source group box via the Port list the port to which "analyzer 1" is
4
connected.
...................................................................................................................................................................................................
Select in the Source group box via the Trib list the desired tributary.
5
...................................................................................................................................................................................................
Select in the Destination group box via the Node IP list the SC IP address of E-C
6
(see section
SC nodes" (p.
...................................................................................................................................................................................................
Select in the Destination group box via the Port list the port to which "analyzer 2" is
7
connected.
...................................................................................................................................................................................................
Select in the Destination group box via the Trib list the desired tributary.
8
...................................................................................................................................................................................................................................
365-374-198R10.5.4
Issue 1 July 2009
A Create New Path screen appears, requesting you to provide information.
Procedure 10-14: "Setting the IP address and O
10-81)).
Procedure 10-14: "Setting the IP address and O
10-81)).
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Procedure 10-21: 1+1 protection test
S 1+1 protection.
S system parameters of the
S system parameters of the
ONNS test
10-99