Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 334

Power, software, and circuit pack installation
...................................................................................................................................................................................................................................
Blank face plate
The maximum upward and downward displacement of the plastic latches shall not exceed
5 mm to avoid any destruction.
Mounting order
Mount the circuit packs in the following order:
...................................................................................................................................................................................................
Insert one CTL unit into slot "CTL W" (#11). If 1+1 CTL protection is required, a second
1
CTL unit must be inserted later (see section
unit" (p.
Important! Make sure that the CTL unit contains a CompactFlash
E software and that the flash card is secured by the protecting bar (see section
Procedure 5-5: " E software installation" (p.
Result:
The LED behavior of the CTL during the boot process is as follows:
1. The "Fault" LED is illuminated.
2. The "Active" LED flashes.
3. The "Fault" and "Active" LEDs flash.
4. The "Fault" LED is illuminated and the "Active" LED flashes.
5. The "Fault" and "Active" LEDs flash.
6. The "Fault" LED flashes and the "Active" LED is illuminated.
After the boot process the following must be observed:
• The fans have reduced their speed.
• The "Fault" LED is flashing and the "Active" LED is permanently illuminated.
• The "M " and "AB " LEDs on the User Panel are illuminated.
Troubleshooting: If the conditions described above cannot be observed, refer to
appendix A, section
...................................................................................................................................................................................................
Push the XC unit (worker) firmly into slot "XC W" (#9).
2
Result:
1. The "Active" LED flashes.
2. The "M ", "MJ" and "AB " LEDs on the User Panel are illuminated.
Troubleshooting: If the conditions described above cannot be observed, check that the
XC unit is plugged correctly. If that does not solve the problem, replace the XC unit
(worker).
...................................................................................................................................................................................................................................
5-60
7-34)) to avoid the possibility of a database corruption.
The E boots automatically (takes about 15 to 20 minutes).
Procedure A-4: "CTL failure" (p.
After about 20 seconds the following must be observed:
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Software and circuit pack installation
Procedure 5-6: Mounting the circuit packs
Procedure 7-8: "Mounting the CTL protection
5-19)).
A-8).
™
card with loaded
365-374-198R10.5.4
Issue 1 July 2009