Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 388

Stand-alone test procedures
...................................................................................................................................................................................................................................
Procedure 8-1: LED test
Overview
This test ensures the functionality of the LEDs on all circuit packs as well as on the User
Panel. The "PWR O " LED on the User Panel and the fan unit LEDs are not affected by
the LED test.
Test procedure
Proceed as follows to perform an LED test:
...................................................................................................................................................................................................
Push the "LED TEST" button on the User Panel to test the circuit pack and User Panel
1
LEDs.
PWR ON
CIT (LAN)
Result:
seconds.
E
N D O F S T E P S
....................................................................................................................................................................................................................................
LED test failure
In the case of an LED test failure (not all LEDs illuminate), please refer to appendix A,
section
...................................................................................................................................................................................................................................
8-2
User Panel
NE ACTY
CR
FE ACTY
MJ
ACO
MN
LED TEST
ABN
All circuit pack and User Panel LEDs should illuminate for about three
Procedure A-8: "LED test failure" (p.
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
A-14).
Procedure 8-1: LED test
365-374-198R10.5.4
Issue 1 July 2009