Power, software, and circuit pack installation
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................
If the CompactFlash
10
CompactFlash
using does not allow for this procedure, make sure that the used slot is not being accessed
(the LED is not flashing for about 5 seconds) before continuing.
...................................................................................................................................................................................................
Eject the CompactFlash
11
with CompactFlash
E
N D
O F
...................................................................................................................................................................................................
Install CompactFlash
Proceed as follows to insert the CompactFlash
the CTL unit:
...................................................................................................................................................................................................
Locate the Security Bar for the CompactFlash
1
CTL unit as shown below.
...................................................................................................................................................................................................................................
365-374-198R10.5.4
Issue 1 July 2009
™
card driver software that you are using requires you to stop the
™
card before ejecting it, stop the card now. If the software that you are
™
card from the CompactFlash
™
card adapter) of the PC.
S T E P S
™
card in CTL
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Software and circuit pack installation
Procedure 5-5: NE software installation
™
slot (or from the PCMCIA slot
™
card with the new loaded software into
™
card that is located on the top edge of the
5-29