Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 482

Network establishment and testing
...................................................................................................................................................................................................................................
Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
2. CAT5 crossover LA cable with RJ-45/RJ-45 connectors (see chapter 4,
"CIT connection (LA crossed)" (p.
3. SDH/SO ET analyzer
The required transmission rate depends on the optical circuit packs used within the
ring. The optical circuit pack with the lowest transmission rate determines the
transmission rate which should be used for the test. For example, if OP2G5 and OP10
circuit packs are used, an STM-16/OC-48 transmission signal is required.
4. ESD wrist strap.
Prerequisites
Prior to performing this task, you must have done the following:
1. Established the fiber connections (see section
cables" (p.
2. Logged in to WaveStar
"Starting the WaveStar
been enabled during WaveStar
3. If DCC protection is required, the DCC channels of all used S CP/UPSR ports must
be configured correctly (see section
...................................................................................................................................................................................................................................
10-44
®
CIT PC
10-4)).
®
CIT as Super User (see chapter 5, section
®
CIT application" (p.
®
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Procedure 10-8: SNCP/UPSR test setup
4-72))
Procedure 10-1: "Connecting the fiber
5-18)) if WaveStar
CIT installation.
Procedure 10-2: "Provision DCC" (p.
Network establishment
Figure 4-48,
Procedure 5-4:
®
CIT User Login has
10-12)).
365-374-198R10.5.4
Issue 1 July 2009