Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 478

Network establishment and testing
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................
All other parameters in the window shall remain on the default values and not been
11
changed.
...................................................................................................................................................................................................
Click Apply and then Yes in the confirmation window.
12
Result:
DCC termination provisioning message appears indicating that the LAPD role has
been set on the user side.
...................................................................................................................................................................................................
Click OK, then click Close.
13
...................................................................................................................................................................................................
Repeat
14
To do that, enter the following:
• The E TID as NE Name
• 1675 LambdaUnite MSS as NE Type
• OSI as Connection Type.
To verify that the MS-SPRing/BLSR setup is correct perform the steps mentioned below.
...................................................................................................................................................................................................
In the WaveStar
15
...................................................................................................................................................................................................
Select the existing 4F MS-SPRing# (SDH) or 4F BLSR# (SO ET) on the left-hand side
16
of the window and click the Select button.
Result:
...................................................................................................................................................................................................
Click Close.
17
...................................................................................................................................................................................................
18 In the WaveStar
...................................................................................................................................................................................................
Select the existing 4F MS-SPRing# (SDH) or 4F BLSR# (SO ET) in the Ptn Grp tab on
19
the left-hand side of the window and click the Select button.
...................................................................................................................................................................................................
Select the Protection Group tab.
20
...................................................................................................................................................................................................................................
10-40
If the creation of the MS-SPRing/BLSR protection group was successful, a
Step 1 to Step 13 for all other Es in the ring via remote login.
® CIT System View, select View → Rings → Ring Map....
All Es of the ring should be displayed on the right side of the window.
®
CIT System View of E-A, select View → Protection....
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Procedure 10-7: 4-fiber MS-SPRing/BLSR test setup
Network establishment
365-374-198R10.5.4
Issue 1 July 2009