Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 290

Power, software, and circuit pack installation
...................................................................................................................................................................................................................................
Click Next.
Important! This configuration can only be done during installation.
Result:
...................................................................................................................................................................................................
Select WaveStar CIT and click Next.
10
Result:
...................................................................................................................................................................................................
11 Select the WaveStar
that you do not wish to install.
Result:
The following components should be selected in all cases:
• "Cut Through View"
• "Command Builder"
• "U ITE Graphical Package" → " etwork View" will be selected automatically.
Click Next.
...................................................................................................................................................................................................
Select the Yes option to install the OSI protocol.
12
Result:
After the installation the InstallShield Wizard Complete window appears with two
options:
• "Yes, I want to restart my computer now"
• " o, I will restart my computer later".
...................................................................................................................................................................................................
13 Select "Yes, I want to restart my computer now" to ensure a proper installation of the
OSILLC driver.
...................................................................................................................................................................................................
Remove the WaveStar
14
...................................................................................................................................................................................................................................
5-16
The Setup Type window appears.
The Select Components window appears.
®
CIT components that you wish to install, and clear the components
A Question window appears.
That component is needed for the use of TL1 commands.
That component is needed for the creation of TL1 scripts.
That component is needed for the use of the graphical network view in WaveStar
CIT.
®
The WaveStar CIT will be installed. This will take a few minutes.
®
CIT CD-ROM from the CD-ROM drive after the reboot.
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Software and circuit pack installation
®
Procedure 5-3: WaveStar
365-374-198R10.5.4
Issue 1 July 2009
CIT installation
®