Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 216

System cabling and final assembly
...................................................................................................................................................................................................................................
Procedure 4-4: STM-1e cable assembly instructions
Description
There are the following type of connectors:
• IMS — type 3320.52.1420.0D5 (45°)
• IMS — type 2630.52.1310.0D5 (straight)
IMS
Important! Use of the correct tools to ensure a proper connection.
...................................................................................................................................................................................................
1 Strip the cable according to the dimensions indicated in the next figure and tin the center
conductor.
Important! The stripping lengths depend on the are connector type!
...................................................................................................................................................................................................
Pull the crimp outer ferrule over the stripped cable.
2
...................................................................................................................................................................................................
3 Pull back the cable braid.
...................................................................................................................................................................................................
Push the center conductor and the dielectric into the connector housing until the dielectric
4
stops.
...................................................................................................................................................................................................
5 Solder the inner conductor to the center contact of the connector housing.
...................................................................................................................................................................................................
After soldering press the cover into the connector body.
6
...................................................................................................................................................................................................
First roll the cable braid over the termination part (inner ferrule) of the connector and pull
7
the crimp outer ferrule over that braid.
...................................................................................................................................................................................................
Crimp the outer ferrule with a Hexagon Die 4.6 — AGK 3068 by using the Crimp Tool
8
— AGK 2365.
E
N D O F S T E P S
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
4-46 Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
External cable installation
Procedure 4-4: STM-1e cable assembly instructions
365-374-198R10.5.4
Issue 1 July 2009