Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 246

System cabling and final assembly
...................................................................................................................................................................................................................................
Optical circuit packs
Application packs
The following pack types are available:
• OP155M
• OP622
• OPLB
• OP2G5, OP2G5D, OPT2G5
• OP10, OP10D
• GE1/SX4, GE1/LX4
• GE10PL1/1A8.
For a complete and up-to-date list of all available circuit packs with the respective
comcodes, please refer to the Engineering Drawings ED8C948-10 and ED8C948-20. For
ordering information, see
Cable data
Important! Only the fiber cables with listed comcode (see Engineering Drawings) are
allowed to be used, otherwise the proper functioning of the system cannot be
guaranteed. Halogen and halogen-free fiber cables are available.
There are the following Single Mode (SM) cables:
• Single Mode (SM)-minicord break-out cable
• Single Mode (SM)-simplex cable.
The following Multi Mode (MM) cables are available (for GE1/SX4 only):
• Multi Mode (MM)-minicord break-out cable
• Multi Mode (MM)-simplex cable.
Connector data
LC connectors with an angled boot of 40-45 degrees are used for termination to port units
(blue connector for SM). The LC boot must remain freely rotatable around the connector
length axis after termination, in order to adjust its orientation to the fiber routing direction
without damaging the fiber.
OP155M
The following figure shows the layout of the OP155M circuit pack (KFA18).
...................................................................................................................................................................................................................................
4-76
"Related information" (p.
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Optical circuit packs
xxxviii).
Fiber cabling
365-374-198R10.5.4
Issue 1 July 2009